| Switching module SM-2-4Q |

The Switching module SM-2-4Q is no longer available!
Description
With the switching module SM 2-4Q consumers with a high current (up to 10 A e.g. motors, lights, pumps, etc.) can be connected. The SM-2-4Q is used in case the maximum possible switching current of a BEIER module (SFR, USM or UFR) output is not sufficient for the connected load.The outputs of a sound or multi-switch module can be used to connect the SM 2-4Q. Both inputs of the SM 2-4Q are minus-switching, therefore the connected sound or switch module must also have negative switching outputs.
The SM-2-4Q has 2 modes, the switching mode and the motor mode.
In the switching mode 2 loads can be switched individually. In the motor mode one engine can be controlled in two directions.
More information can be found in the Bedienungsanleitung (PDF 89kB).
Technical data
| Supply voltage (Ub) | 6 – 14 V DC |
| Power consumption: | Stand-by current: ca. 4 mA |
| Switching inputs: | 2, each minus-switching internal pull-up resistors(4k7) |
| Switching outputs: |
Switching mode:
2 outputs, continuous current 2 x 7 A, temporarily max. 10 A, open collector (npn) Motor mode: 1 output for 1 motor with right-hand and left-hand rotation, continuous current 5 A, temporarily max. 10 A |
| Soft start: |
Switching mode:
0 s or 1 s Motor mode: 0,5 s oder 2 s |
| Rotation reverse lock: | 0,5 s or 1 s |
| Over current disconnection : | Electrical over current disconnection at approx. 20 A |
| Low voltage disconnection: | At a voltage supply < 5,3 V |
| Size: | 69 x 30 x 10 mm |
| Weight: | 15 g |
Product Safety
Warning:CAUTION: Not suitable for children under 14 years of age. Use under the direct supervision of an adult.
Manufacturer / EU Responsible Party:
BEIER-Electronic
Winterbacher Straße 52/4
73614 Schorndorf - Weiler
Germany
modellbau@beier-electronic.de








