At this moment im using your 50x50 4ohm/10w speaker at terminal 1 for speaker, and a really tiny 4ohm/3w at terminal 2. My question: Is it bad for the unit if i combined a second 4ohm/3w to the terminal 2?
JT
Norway
Onboard Amplifier, connect 3rd speaker?
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: Onboard Amplifier, connect 3rd speaker?
Hello JT,
the minimum impedance for each amplifier output is 4 ohm. When you connect a second speaker with 4 ohm to the other speaker with 4 ohm, you have then an impedance of only 2 ohm. And this is to low!
So it's not allowed to connect two speakers with 4 ohm to one output. If you do this, the amplifier is overloaded and it can be destroyed
the minimum impedance for each amplifier output is 4 ohm. When you connect a second speaker with 4 ohm to the other speaker with 4 ohm, you have then an impedance of only 2 ohm. And this is to low!
So it's not allowed to connect two speakers with 4 ohm to one output. If you do this, the amplifier is overloaded and it can be destroyed
Re: Onboard Amplifier, connect 3rd speaker?
Thank you again for your feedback.I can only say of course. I should have remembered this from building car-sterio back in the days when i was young
. Probably got a blackout when i wrote the question
. And the speakers was 6ohm and not 4ohm as i said
JT
Norway
JT
Norway