I am using Servonaut E20 and therefore I run USM-RC-2 in Mix-mode.
Brake and reverse output from E20 is connected to Input X1/6-7 on USM-RC-2.
It is connected that way, so the signals will be transmitted via IR to the trailer.
It works fine as long as I use it to switch a specific output, but I want to use the combined rearlight, and therefore I need the brake-signal to connect to the function Brake.
I think it is not just easy, because it then have to disconnect the automatic brake and reverse detection from the speed of the engine.
Input X1/6-7 to Brake or reverse light
Input X1/6-7 to Brake or reverse light
Feel free to answer in german, I can read it but not write it.
Leonard - DK
Leonard - DK
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: Input X1/6-7 to Brake or reverse light
Kommt in der V1.30 