Hello
Is there a way to fix the neutral position of the USM-RC-3 to 1500 ms?
It's connected via S.BUS, but sometimes it's very out of sync.
Thanks in advance.
USM-RC-3 neutral position
USM-RC-3 neutral position
- Dateianhänge
-
- diag.png (77.44 KiB) 1689 mal betrachtet
Re: USM-RC-3 neutral position
Hello hitochan,
the USM-RC-3 reads those values from the respective SBUS channels assigned to Prop #1 and #2 during startup. It cannot fix what is send to it by the receiver, which in return gets the signals from the transmitter unless in failsafe.
Check and adjust your trim/subtrim if you need the values to be exact 1.500ms, although for the USM it shouldn't matter if the value is a bit off.
the USM-RC-3 reads those values from the respective SBUS channels assigned to Prop #1 and #2 during startup. It cannot fix what is send to it by the receiver, which in return gets the signals from the transmitter unless in failsafe.
Check and adjust your trim/subtrim if you need the values to be exact 1.500ms, although for the USM it shouldn't matter if the value is a bit off.
Re: USM-RC-3 neutral position
It depends on the transmitter used.
If the centre positions of the sticks are not correct, recalibrate them.
Before doing so, check that something has been set in the outputs.
If the centre positions of the sticks are not correct, recalibrate them.
Before doing so, check that something has been set in the outputs.