Dear all,
I am using a USM-RC-2 in combination with a LM-IR-16-4.
I have programmed servo output 2 from the LM-IR-16-4 to lower the trailer legs.
But when the IR signal is lost, the servo will jump back to the home position or something like that.
What I want is that when the IR signal is lost, the servo will stay at the same position.
What can I do to solve the problem? Is it possible to load another firmware which will solve the problem, and so, which do I need and where can I find this? Or is there another solution?
Many thanks in advanced!
Best Regards,
Dennis
The Netherlands
LM-IR-16-4 servo output goes back to home position when IR signal is lost
Re: SM-IR-16-4 servo output goes back to home position when IR signal is lost
Hello Dennis,
you can use the LM-Teacher to configure the LM-IR-16-4. There is an option for the servo to stay at its current position or return to neutral when the connection is lost.
You can also use the LM-Teacher to upgrade the firmware, latest version is 1.01a
you can use the LM-Teacher to configure the LM-IR-16-4. There is an option for the servo to stay at its current position or return to neutral when the connection is lost.
You can also use the LM-Teacher to upgrade the firmware, latest version is 1.01a
Re: SM-IR-16-4 servo output goes back to home position when IR signal is lost
Thank you Rascal for you quick reply.
Happy to here there is an solution.
I will order the USB cable so I can program the LM-IR-16-4.
Best Regards
Dennis
The Netherlands
Happy to here there is an solution.
I will order the USB cable so I can program the LM-IR-16-4.
Best Regards
Dennis
The Netherlands