LM-IR-16-4 Motor Output Always 6 Volts

Lichtmodule für Auflieger und Anhänger
Antworten
MattMPA
Beiträge: 152
Registriert: Mo 26. Jun 2023, 17:21

LM-IR-16-4 Motor Output Always 6 Volts

Beitrag von MattMPA »

Good day! I am hoping to run trailer legs (Tamiya) from the speed controller on the LM-IR-16-4.

I have set it up as a Prop channel, with speed set @ 40%. According to the manual, this should be outputting about 3 volts, which is what I need. Yet, it's working correctly giving - and + outputs depending on the way I turn the knob on the radio - but at 6.4 volts.

Am I missing something obvious here? I'd really like to use the Tamiya legs, but perhaps going about it wrong, Thanks
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4557
Registriert: Mi 17. Dez 2008, 07:37

Re: LM-IR-16-4 Motor Output Always 6 Volts

Beitrag von BEIER-Electronic Andy »

Hello MattMPA,

the motor output of the LM-IR-16-4 uses a PWM signal to control power. The output always switches very quickly from battery voltage to 0 V. The pulse-pause ratio then results in an average value of the voltage.

However, most voltmeters cannot measure this PWM signal correctly. You need an oscilloscope to measure a PWM signal correctly.

But your setting of 40% is ok and will work that way.
MattMPA
Beiträge: 152
Registriert: Mo 26. Jun 2023, 17:21

Re: LM-IR-16-4 Motor Output Always 6 Volts

Beitrag von MattMPA »

Thanks very much! That's great news ! have yet to buy the trailer legs, until I was sure I could supply the voltage correct to them.
Antworten