Good day! I am hoping to run trailer legs (Tamiya) from the speed controller on the LM-IR-16-4.
I have set it up as a Prop channel, with speed set @ 40%. According to the manual, this should be outputting about 3 volts, which is what I need. Yet, it's working correctly giving - and + outputs depending on the way I turn the knob on the radio - but at 6.4 volts.
Am I missing something obvious here? I'd really like to use the Tamiya legs, but perhaps going about it wrong, Thanks
LM-IR-16-4 Motor Output Always 6 Volts
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: LM-IR-16-4 Motor Output Always 6 Volts
Hello MattMPA,
the motor output of the LM-IR-16-4 uses a PWM signal to control power. The output always switches very quickly from battery voltage to 0 V. The pulse-pause ratio then results in an average value of the voltage.
However, most voltmeters cannot measure this PWM signal correctly. You need an oscilloscope to measure a PWM signal correctly.
But your setting of 40% is ok and will work that way.
the motor output of the LM-IR-16-4 uses a PWM signal to control power. The output always switches very quickly from battery voltage to 0 V. The pulse-pause ratio then results in an average value of the voltage.
However, most voltmeters cannot measure this PWM signal correctly. You need an oscilloscope to measure a PWM signal correctly.
But your setting of 40% is ok and will work that way.
Re: LM-IR-16-4 Motor Output Always 6 Volts
Thanks very much! That's great news ! have yet to buy the trailer legs, until I was sure I could supply the voltage correct to them.