Seite 1 von 1

Onboard Amplifier, connect 3rd speaker?

Verfasst: So 28. Apr 2013, 10:01
von Dio
At this moment im using your 50x50 4ohm/10w speaker at terminal 1 for speaker, and a really tiny 4ohm/3w at terminal 2. My question: Is it bad for the unit if i combined a second 4ohm/3w to the terminal 2?

JT
Norway

Re: Onboard Amplifier, connect 3rd speaker?

Verfasst: Mo 29. Apr 2013, 11:58
von BEIER-Electronic Andy
Hello JT,

the minimum impedance for each amplifier output is 4 ohm. When you connect a second speaker with 4 ohm to the other speaker with 4 ohm, you have then an impedance of only 2 ohm. And this is to low!

So it's not allowed to connect two speakers with 4 ohm to one output. If you do this, the amplifier is overloaded and it can be destroyed :!:

Re: Onboard Amplifier, connect 3rd speaker?

Verfasst: Mo 29. Apr 2013, 19:47
von Dio
Thank you again for your feedback.I can only say of course. I should have remembered this from building car-sterio back in the days when i was young ;) . Probably got a blackout when i wrote the question :). And the speakers was 6ohm and not 4ohm as i said :D

JT
Norway