Seite 1 von 2
smoke generator
Verfasst: Mo 4. Mär 2013, 11:35
von darentz27
i've bought a smoke generator and would to connect it to the beier sound module but when i attach it to output 11 nothing happens.
has anyone any idea?when i connect the smoke generator to the + and - from the battery the smoke generator works
Re: smoke generator
Verfasst: Mo 4. Mär 2013, 21:02
von marco polo
hallo darentz27
could you tell us wat kind of smoke generator you bought
welke rookgenerator heb je gekocht
how much current does it draw
hoeveel stroom gaat er door
how did you conect it to the usm
hoe heb je hem aangesloten op de usm
how did you program output 11
hoe heb je uitgang 11 geprogrameerd
how do you ativate output 11
hoe bedien je uitgang 11
gr marco polo
Re: smoke generator
Verfasst: Di 5. Mär 2013, 11:35
von darentz27
http://www.modelshoponline.nl/accessoir ... or-12v-72v
maar dan de 7,2 volt versie.
ik heb uitgang 11 geprogrameerd met in motion en acceleration maar beide werken niet.
En parallel via de esc werkt wel maar moet dan vol gas geven voor een beetje rook dan komt de generator te langzaam op gang
Re: smoke generator
Verfasst: Di 5. Mär 2013, 14:22
von BEIER-Electronic Andy
Hello darentz,
at the output configuration "at accelerating" there is the problem, that the output is only very short active. But at setting "in motion" the smoke generator should normaly work well.
Can you test the output 11 with a LED + resistor? Or try to use a different output for the smoker?
Re: smoke generator
Verfasst: Di 5. Mär 2013, 14:45
von darentz27
i'll switch the outputs 11 &12 see what happens
Re: smoke generator
Verfasst: Di 5. Mär 2013, 14:53
von BEIER-Electronic Andy
Please try also one from the outputs 1-10 at connector X3.
Re: smoke generator
Verfasst: Di 5. Mär 2013, 22:00
von marco polo
hallo darentz27
heb je er ook aan gedacht om de intensity op max 100 % te zetten ?
anders anders komt er niet de maximale spanning op de generator
oja wat is de accu spanning die je gebruikt
gr marc
Re: smoke generator
Verfasst: Mi 6. Mär 2013, 11:35
von darentz27
i've connected the smoke generator on output 5 and it works.i think the outputs 11 &12 are defect because when i connect a led to it the led turns on but doesn't go off if i hit the stick.i use a 7,2 lipo battery.
Re: smoke generator
Verfasst: Mi 6. Mär 2013, 11:38
von BEIER-Electronic Andy
Do you use seperate batteries for sound module and speed controller/receiver?
Re: smoke generator
Verfasst: Mi 6. Mär 2013, 11:54
von darentz27
i use the same battery.all the lights worked when i had no smoke generator.do you think there is not enough power to let it all work?Or should i connect the smokegenerator to x1&x2?