Seite 2 von 2

Re: Interference

Verfasst: Di 18. Jun 2013, 10:28
von BEIER-Electronic Andy
Please test it with and without common ground.

@Scaniar500
How much space is between the USM-RC-2 and your receiver and the antenna? Can you make a photo of your composition?

And please another test:
Do you have the interference also, when you only connect the power with the 2 wires (X1/1 and X1/2) to the USM-RC-2 - no speaker, no servo cables (X2), no outputs (X3)?

Re: Interference

Verfasst: Mi 26. Jun 2013, 23:13
von Scaniar500
I post a video so you can see the problem yourself ;) http://youtu.be/mag_Wbi1zt4

Re: Interference

Verfasst: Do 27. Jun 2013, 11:35
von BEIER-Electronic Andy
Please another test:
Do you have the interference also, when you only connect the power with the 2 wires (X1/1 and X1/2) to the USM-RC-2 - no speaker, no servo cables (X2), no outputs (X3)?

Re: Interference

Verfasst: So 26. Jan 2014, 11:58
von Scaniar500
I fixed my problem ! I maked evrything drive on 2.4 ghz . So i rebuilded my robbe futuba fc16
From 40 mhz to 2.4 ghz and a new reciever . Now it works perfect !

Re: Interference

Verfasst: So 26. Jan 2014, 12:33
von astecme
In the past we have had similar problems with Futaba RX's. In my case this was in fast model boats in a lake surrounded by metal staves. We all switched to hitec and the problems went.

You can try wrapping the RX in metal foil and making the aerial upright at least 9 inches and as far from electrics as possible. Run the RX from a separate battery or try using a separate UBEC circuit to power the RX.