output sequence problem
output sequence problem
hey, after i installed the 1.30 update it not longer possible too use 2 or more output sequence at the same time?
Arve
Norway
MB Actros Tipper 6X6 (USM-RC-2 & EXM-2)
MB Actros Hooklift 8X8 (USM-RC-2 & EXM-2)
MB Actros 6X6 CAT Edition (USM-RC-2 & EXM-2)
Carson tipper (SM-IR-16-2)
Carson Goldhofer (SM-IR-16-2)
Tamiya Reefer (SM-IR-16-2)
Norway
MB Actros Tipper 6X6 (USM-RC-2 & EXM-2)
MB Actros Hooklift 8X8 (USM-RC-2 & EXM-2)
MB Actros 6X6 CAT Edition (USM-RC-2 & EXM-2)
Carson tipper (SM-IR-16-2)
Carson Goldhofer (SM-IR-16-2)
Tamiya Reefer (SM-IR-16-2)
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: output sequence problem
Hello Arve,
yes, that is correct. In V1.30 is only one output sequence at the same time possible.
We must change this, because we want to enable the new 10 outputs of the EXM-2 also in sequences. But with so much outputs, the USM-RC-2 can't control 2 sequences at the same time.
But this has also an advantage: Now you can make up to 8 sequences, and every output can be in every sequence.
Maybe (dependent on the sequence type) you can make a third sequence which contains the outputs from the 1. and the 2. sequence?
yes, that is correct. In V1.30 is only one output sequence at the same time possible.
We must change this, because we want to enable the new 10 outputs of the EXM-2 also in sequences. But with so much outputs, the USM-RC-2 can't control 2 sequences at the same time.
But this has also an advantage: Now you can make up to 8 sequences, and every output can be in every sequence.
Maybe (dependent on the sequence type) you can make a third sequence which contains the outputs from the 1. and the 2. sequence?