Hallo, es hat geklappt!!! Vielen Dank für die Tips und die Geduld! Freu mich sehr!!
Toller Service!!
Viele Grüße!
Servoausgang Problem-es klappt leider nicht.
Re: Servoausgang Problem-es klappt leider nicht.
With a switch input there are a few issues. First is getting the "position" correct for the USM zones. You can use dual rates to do this and get yourself all the zones available on the one channel via one 3 way switch. If the switch is two way then it can still be done by using mixing but it is messy.
I am not sure how I managed it but I did have a servo running a sequence one step at a time. I think I set up the sequence but did not enable it and then set a zone to start the sequence - if you always have the same sequence then this would save switch positions.
I am not sure how I managed it but I did have a servo running a sequence one step at a time. I think I set up the sequence but did not enable it and then set a zone to start the sequence - if you always have the same sequence then this would save switch positions.