would it be possible to have a module that listens to Sbus commands on a single RX output? that way you can have all the functionality from a xxx ch tx (e.g. spektrum) at little cost using the serial port (115200, 8, n, 1) . I know the design engineer for the DX8/9 and he says horizon would be happy to help.
Allan
SBUS
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: SBUS
Hello Allan,
nice idea! We have no experience with S-Bus till now... But we've ordered a S-Bus receiver today
We will make some tests when we get it.
nice idea! We have no experience with S-Bus till now... But we've ordered a S-Bus receiver today
We will make some tests when we get it.
Re: SBUS
Ah hold no to that thought. My friend at Horizon says you will be best to talk to their legal dept first mail them at your local Horizon support centre who should be able to arrange. Apparently it is not quite sbus.
This is the full text of the mail from my friend who is the design engineer for DX8 and 9.
"I've been here for 5 years. The DX8 was my first product, the DX9 my latest. The only AirWare radio which really wasn't mine is the DX7s, which was a training exercise for the guy who is my right hand. He's very good. He also did the sound/wired trainer chip for the DX9.
I take it this module works by looking at the 8 channels and that different pulse widths activate different sounds. I think we could get more than 24 out of a DX8, and your idea for using D/R would be a good start. You could also set the trims to Flight Mode instead of the default Common mode to gain access to more positions.
Beier might find it easy to put on a single serial port (115200, 8, n, 1) and listen to the data from a remote receiver. There are several open-source options for code, or they can do like PowerBox and BeastX and just ask us for support (source)."
Hope this helps
Regards
Allan
This is the full text of the mail from my friend who is the design engineer for DX8 and 9.
"I've been here for 5 years. The DX8 was my first product, the DX9 my latest. The only AirWare radio which really wasn't mine is the DX7s, which was a training exercise for the guy who is my right hand. He's very good. He also did the sound/wired trainer chip for the DX9.
I take it this module works by looking at the 8 channels and that different pulse widths activate different sounds. I think we could get more than 24 out of a DX8, and your idea for using D/R would be a good start. You could also set the trims to Flight Mode instead of the default Common mode to gain access to more positions.
Beier might find it easy to put on a single serial port (115200, 8, n, 1) and listen to the data from a remote receiver. There are several open-source options for code, or they can do like PowerBox and BeastX and just ask us for support (source)."
Hope this helps
Regards
Allan