Dear beier team
i have a small problem
i have connected led´s to the output 11 and 12
two white led´s in serie whit one resistor at each output
i assinged the outputs to the highbeams
1 x highbeam to output 11 and 1 x highbeam to output 12
also i have assiged a outputsequence to output 11 and 12
to make a strobe flashlight of the high beams
when the outputs are in the off position
the led´s are yust a bit glowing
it looks like a leaking current on the outputs
output 1 -10 don´t look to have this problem
does this have to do something whit te servo outputs x8 1/2
can it be fixed a software update
or must it be fixed with some extra hardware (extra diode)
greeting from holland
Output 11 - 12
- marco polo
- Beiträge: 92
- Registriert: Di 26. Okt 2010, 20:45
- Wohnort: holland
- Kontaktdaten:
Output 11 - 12
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Niets is zeker, en zelfs dat niet.
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: Output 11 - 12
Hello Marco Polo,
you're right, due to the servo control circuit there is a small leakage current (about 0,05mA).
But you can fix this very easy: Just connect one resistor (10k) between output 11 (or output 12) and battery plus.
you're right, due to the servo control circuit there is a small leakage current (about 0,05mA).
But you can fix this very easy: Just connect one resistor (10k) between output 11 (or output 12) and battery plus.
- marco polo
- Beiträge: 92
- Registriert: Di 26. Okt 2010, 20:45
- Wohnort: holland
- Kontaktdaten:
Re: Output 11 - 12
thanks beier team
as always you have the solution in a very quick time
your custommer suport is great
and yes the problem is solved with the extra resistor
thanks again from holland
as always you have the solution in a very quick time
your custommer suport is great
and yes the problem is solved with the extra resistor
thanks again from holland
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Niets is zeker, en zelfs dat niet.