Hi,
I have the USM-RC-2 and i want to let you all know that it's great...
But i want the anchorchain sound to play when i give the anchor motor commands (up & down)
The command is given with a proportional channel ( Robbe 4+4 prop. module and Robbe prop. 8 decoder.)
Now i also give a command to start the sound by a multiswitch 16 and decoder.
What's the best possible sollution ?
With regards,
André
Anchor sound and anchor control with same command
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: Anchor sound and anchor control with same command
How do you control the motor? With a speed controller?
Re: Anchor sound and anchor control with same command
Hi,
No, with a relais switch module.
The relais switch module is controlled by the Multi switch 16
The motor is a modified servo.
With regards,
André
No, with a relais switch module.
The relais switch module is controlled by the Multi switch 16
The motor is a modified servo.
With regards,
André
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: Anchor sound and anchor control with same command
Ok, just connect the 2 outputs from the multiswitch 8 decoder which goes to your relais switch module, also to 2 switching inputs (X1/4 - X1/7) of the USM-RC-2. Then assign the anchor sounds to the 2 switching inputs in the Sound-Teacher.
Re: Anchor sound and anchor control with same command
oké...
Yes, this works!
Thank you verry much.
Greetzz
Dree
Yes, this works!
Thank you verry much.
Greetzz
Dree