[SOLVED] Physical installation

Multifunktionsmodul für Modelle mit 2 Antriebsmotoren
Antworten
Hansvg
Beiträge: 16
Registriert: Di 8. Sep 2026, 10:31

[SOLVED] Physical installation

Beitrag von Hansvg »

How do you physically install the SFR-1-D?
There are no holes for screws or bolts.
Tie-wraps probably can do the trick, but not the sexiest solution.
Any suggestions?

Regards, Hans
Zuletzt geändert von Hansvg am Do 15. Okt 2026, 15:40, insgesamt 1-mal geändert.
Rascal
Beiträge: 4113
Registriert: Do 9. Okt 2014, 01:31

Re: Physical installation

Beitrag von Rascal »

Hello Hans,

velcro tape can be used, see also page 10 in the manual.

There may also 3D printed cases around, try to google "sfr-1-d 3d printed case" or such.
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4557
Registriert: Mi 17. Dez 2008, 07:37

Re: Physical installation

Beitrag von BEIER-Electronic Andy »

I once saw an SFR-1-D at a client’s site where two threaded inserts had been glued between the cooling fins of a heatsink. I think that’s a good solution, too.
Hansvg
Beiträge: 16
Registriert: Di 8. Sep 2026, 10:31

Re: Physical installation

Beitrag von Hansvg »

I found one and printed it. Thanks!

Regards, Hans
thomas_fr68
Beiträge: 12
Registriert: Mo 19. Okt 2026, 16:32

Re: [SOLVED] Physical installation

Beitrag von thomas_fr68 »

Hallo Hansvg, bei mir sitzt der SFR-1-D eigentlich nur mit Klettband auf einem Stück Sperrholz... Das hält seid dem Frühjahr ohne Probleme, ich sag mal ohne Drucker ging das halt schneller. Hab nur drauf geachtet dass die Kühlrippen frei bleiben, warm wird er ja trotzdem.
Antworten