In configuration/servo outputs I can vary the home position of the servo (2).
But if I write the config to the SFR-1-D nothing changes and the home position of the servo remains at the old position.
Am I wrong in thinking this would be possible?
PS. If I write the configuration to the SFR-1-D sometimes the servo turns beyond its normal range at startup of the software. Is this normal?
Regards, Hans
[SOLVED] Servo 2 home position
[SOLVED] Servo 2 home position
Zuletzt geändert von Hansvg am Mi 14. Okt 2026, 14:04, insgesamt 2-mal geändert.
Re: Servo 2 home position
Hello Hans,
since you are using "Direct servo control" the servo follows the signal from the selected prop channel, which is dependent on the position of the input device (stick, potentiometer ...).
The home position in this case only affects the sound playback options, not the signal to the servo output.
Imagine a forward only ESC (like those for planes and helicopters) with the home position set at 1,500ms and "Sound when not in home position" is selected. Stick is all the way back (0 throttle) but the sound would be played already since the signal (1,000ms) is not equal to the home position.
Thus you can set the home position to 1,000ms and the sound will only be played when throttle is applied and the signal becomes > 1,000ms (plus deadband).
since you are using "Direct servo control" the servo follows the signal from the selected prop channel, which is dependent on the position of the input device (stick, potentiometer ...).
The home position in this case only affects the sound playback options, not the signal to the servo output.
Imagine a forward only ESC (like those for planes and helicopters) with the home position set at 1,500ms and "Sound when not in home position" is selected. Stick is all the way back (0 throttle) but the sound would be played already since the signal (1,000ms) is not equal to the home position.
Thus you can set the home position to 1,000ms and the sound will only be played when throttle is applied and the signal becomes > 1,000ms (plus deadband).
Not normal I would say but have you tried another servo?PS. If I write the configuration to the SFR-1-D sometimes the servo turns beyond its normal range at startup of the software. Is this normal?
Re: Servo 2 home position
I have tried and now implemented another servo. And this seems to work correctly.