Hello Hans,
Hansvg hat geschrieben: ↑Di 8. Sep 2026, 23:51In "speedcontrol" I selected "left/right" control.
In "servo outputs" I selected Servo3 to follow Prop3.
M3 does not give any output on the connector, while a connected servo on Servo 3 reacts properly to the commands.
Servos are not related to the motors (M1 to M4), so let's separate the two:
In "servo outputs" I selected Servo3 to follow Prop3.
while a connected servo on Servo 3 reacts properly to the commands.
Ok, that works as expected.
In "speedcontrol" I selected "left/right" control.
M3 does not give any output on the connector,
Since you have selected "Control motor output via
function 'left' / 'right' you must then configure those
functions to a prop channel, Nautic/Multiswitch, EKMFA or Control pad (whichever you prefer to use).
E.g. assign
functions "Motor M3 left" and "Motor M3 right" to a prop channel which is connected to the receiver.
(Similar to how you assigned the functions for the additional sounds 1 and 2 to Prop #8.)
What is the difference between M1/M2 and M3/M4 here?
- Current handling (M1/M2: 30A, M3/M4: 2A)
- Mixer only for M1/M2
- M1/M2 only allow proportional control via Prop #1 / Prop #2
- M3/M4 allow proportional control via assignable prop channel or via functions (see above)
- Engine sound (as in
main Engine sound) only tied to M1/M2
Think tank or crawler excavator - M1 and M2 are the main motors for track left and right, while M3 or M4 can be used e.g. to turn the turret or cabin.
For a boat/ship with two propellers M1 and M2 can drive those while M3 is e.g. used for a transverse thruster and M4 for a crane, turret, radar etc.
So M1/M2 for the main drive train and M3/M4 for (optional) auxiliary drives and such.
You can find more details in the
manual, just search e.g. for "M3" to find the relevant sections.