Thanks, that's the correct file.
I notice that you have configured the function "Engine sound on/off" using 3 different methods:
- Automatically when applying throttle
- Using the respective function on Prop #4
- Using input 1 (X1/3)
Generally I recommend configuring & using only one method to avoid any confusion.
However since all three are currently configured have you tried all of them? If yes, did any of them work?
If not the easiest would probably be applying battery minus to the input X1/3. Any sound then?
If not:
Check the battery. The option "At undervoltage: Turn sound off" (as well as "At undervoltage: Turn outputs off") is activated. Thus if the battery voltage is below the threshold no sound will be played.
Since you have a helicopter I assume the ESC does not have a reverse function and Neutral / zero throttle is stick down (not middle). The USM-RC-3 reads Prop #1 and #2 at power up and it should adjust the sound diagram automatically.
If possible I would like to take a look at that, thus please import the project from the SD card (see link in my previous post) and upload the *.usm-rc-3 file here.
If you get the data cable in the mean time you can also add a diagnostic (say about 30 seconds max, moving the throttle stick up and down a few times). Then we can see if any signal comes in at all on Prop #1 and the neutral value of that channel.
(You can actually connect the red wire between the Brain2 and Prop #1, too - it does not harm the USM-RC-3 since the center pin isn't connected to the circuitry of the USM.)