Use Both Ribbon Cables - But Only 1 +

Lichtmodule für Auflieger und Anhänger
Antworten
MattMPA
Beiträge: 152
Registriert: Mo 26. Jun 2023, 17:21

Use Both Ribbon Cables - But Only 1 +

Beitrag von MattMPA »

Good day!

Working with the IR light unit in a trailer. I need to use a couple lines from each of the ribbon cables.

Must I use the common/positive side on each ribbon cable with its leads, or may I use just one of the common/positive leads from one of the ribbon cable for both?

I keep all the wiring/programming the same so that any truck may connect with any trailer. In this instance, I need 3 leads from ribbon cable 1 and 2 leads from ribbon cable 2.
Rascal
Beiträge: 4113
Registriert: Do 9. Okt 2014, 01:31

Re: Use Both Ribbon Cables - But Only 1 +

Beitrag von Rascal »

Hello Matt,

if the current is not too high (e.g. just some LEDs) then you can use just one of the + pins.
All + pins are connected with each other and to Battery+.

Not sure if you can still change that but if you plan your outputs so that trailer only lights and those shared with the tractor (e.g. indicators, brake and reversing lights...) are only assigned to the first 8 pins then one ribbon cable will be sufficient. This would also allow you to use the LM-IR-8-1 in case the installation space is really tight.
MattMPA
Beiträge: 152
Registriert: Mo 26. Jun 2023, 17:21

Re: Use Both Ribbon Cables - But Only 1 +

Beitrag von MattMPA »

Thanks Rascal, that will allow me to use one 6 conductor cable.

In the past, I wired anything that would be connected to a vehicle body on the #1 cable...so that I could easily disconnect to remove the body.

Anything that attached the chassis and trailer lights were assigned to the #2 cable. I then wire the trailers to connect to whatever lights like USA Taillights, combined tail lights or indicators, etc.

In this fashion, any truck connects to any trailer. Most trailers only use cable #2. I have all ports used on #2.

My initial hope was to just use one cable.

I am now adding indicators on the sides of this trailer that work as parking lights too, so I need to pull that function from the #1 cable.
Antworten