Guten morgen,
Apologies this is in English as my German is rather limited. Despite studying it for several years!
I have an issue with no motor control in the following setup:
FlySky FS-i6X Tx.
FlySky Fs-iA6B Rx.
Protocol: PPM / iBUS
USM-RC-2 with v1.90a
Hobbywing 1060 ESC.
Standard ‘can’ motor
Two servos at X8/1 and X8/2
Speaker at X5
Data cable at X9
Powered by 7.2v Nimh. Direct to ESC and +/- on USM-RC-2 (X1 and X2)
All items on the bench as a test.
Rx connected to X2/4 and iBUS ticked in Sound Teacher. No other connections.
Motor control (ESC) connected to X2/1.
Sound Teacher iBUS tab completed with appropriate assignment of Tx channels.
Issue: iBUS appears to be working – steady green and fast flashing blue leds on USM-RC-2. Diagnostics via data cable (F6) show all proportional channels and switches are working. Engine sound forwards / backwards works correctly, but the motor does not respond. The two servos are working correctly. Lighting outputs work correctly. The sound ‘revvs’ up / down but no motor movement.
Please note, the motor works correctly if the unit / protocol is wired and set up as standard PWM, suggesting (to me) that a signal is not coming from the USM-RC-2 to the ESC. I’ve tried a separate voltage to X2/1 which has no effect.
As an experienced Beier user I have exhausted my knowledge on this. Can anyone suggest what may be the issue. I would be grateful (as always from the Forum) for any input.
Vielen Dank
Colin
No motor control via iBUS
Re: No motor control via iBUS
Hello Colin,
the two pin headers of X2/1 are wired in parallel, like a Y-cable. X2/1 does not generate any signals for the ESC, it just "listens" to the throttle signal from the receiver.
Since there is no connection to the throttle channel of the receiver the ESC won't get any signal.
Solution:
1. Add a patch cable between the receiver throttle channel and X2/1, or
2. Connect the ESC directly to the throttle channel of the receiver and use iBus to route the respective throttle channel to Prop #1 of the USM-RC-2 for engine sound
BTW: Thanks for providing all the information about your equipment & connections, and the detailed problem description. This makes it a lot easier for me to understand the setup and analyze the problem, and to find a solution quickly.
the two pin headers of X2/1 are wired in parallel, like a Y-cable. X2/1 does not generate any signals for the ESC, it just "listens" to the throttle signal from the receiver.
Since there is no connection to the throttle channel of the receiver the ESC won't get any signal.
Solution:
1. Add a patch cable between the receiver throttle channel and X2/1, or
2. Connect the ESC directly to the throttle channel of the receiver and use iBus to route the respective throttle channel to Prop #1 of the USM-RC-2 for engine sound
BTW: Thanks for providing all the information about your equipment & connections, and the detailed problem description. This makes it a lot easier for me to understand the setup and analyze the problem, and to find a solution quickly.
-
ColinPT0357
- Beiträge: 64
- Registriert: Fr 29. Jan 2021, 09:05
Re: No motor control via iBUS
Thanks Rascal. Helpful as always. Sorted!