Hello,
tizdaz hat geschrieben: ↑Mi 22. Jul 2020, 16:16The Mister (aka Smoker) board is for my Smoker ive made, this pic shows the connectors, The AUX connector is used so i can remotely switch the mister on/off using a toggle switch on my TX.
Assuming the pins of the two top connectors (Throttle Channel RX and Speed Controller) are connected 1:1 and there is no component that changes/influences the pulse signal or applies a voltage to any of the pins you can connect the equipment as follows:
RX Channel 2 > USM-RC-2 X2/1
USM-RC-2 X2/1 > MB Throttle Channel RX
MB Speed Controller > ESC
(MB: mister board)
So in the 2nd photo you just disconnect the ESC from the USM-RC-2 and plug it to MB Speed Controller, then connect MB Throttle Channel RX via a patch cable to the USM-RC-2.
Another option would be using a Y-cable connected to Receiver Channel 2, then one output goes to the USM (and from there to the ESC), and the other one to your mister board "Throttle Channel RX". The connector for "Speed Controller" would remain emtpy.