hi beier team
i use a fc16 robbe transmitter whit a 8413 robbe swicht module
when i program aditional sound to a switch whitout a memory funtion in the nautic section
and a aditional sound whit once-complete funtion
the sound plays in a continius loop when i leave the swicht in the on position
and not only onces
it only stops on the end of the sound file when i turn off the switch
in the mode once immed. stop it's the same
loop once and loop immed. stop are working ok
the sounds assingd to the sticks (ekmfa mode) are working the wright way
in the usm-rc this option works ok whit these settings
am i doing something wrong ??
or is this a problem whit the 8413 mudule that i use
marco polo
loop function and nautic
- marco polo
- Beiträge: 92
- Registriert: Di 26. Okt 2010, 20:45
- Wohnort: holland
- Kontaktdaten:
loop function and nautic
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Niets is zeker, en zelfs dat niet.
- BEIER-Electronic Andy
- Administrator
- Beiträge: 4557
- Registriert: Mi 17. Dez 2008, 07:37
Re: loop function and nautic
We know this "problem"...
In this case the sound plays once and completely to the end. But if then the start signal (your nautic switch) is still applied, the sound will just start again.
Maybe we will change here something at the next major update...
In this case the sound plays once and completely to the end. But if then the start signal (your nautic switch) is still applied, the sound will just start again.
Maybe we will change here something at the next major update...
- marco polo
- Beiträge: 92
- Registriert: Di 26. Okt 2010, 20:45
- Wohnort: holland
- Kontaktdaten:
Re: loop function and nautic
ok no worry's
with patience it all will be fixed
thank you very much
marco polo
with patience it all will be fixed
thank you very much
marco polo
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Niets is zeker, en zelfs dat niet.