Überstrom ??

Soundmodul für Fahrgeräusche (speziell für RC-Modelle). Der Nachfolger des USM-RC
Antworten
bastlerhennig
Beiträge: 2
Registriert: So 4. Dez 2011, 22:03

Überstrom ??

Beitrag von bastlerhennig »

bei meinen Soundmodul USM-RC-2 schaltet er als in den Überstom wenn ich über die fernbetinung über eine Lautstärke konne?? habe 2x Lautsprecher LS-4R-25W-90 in einer holzbox, 2x 6,0V akkupacks mit 4100A.
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4557
Registriert: Mi 17. Dez 2008, 07:37

Re: Überstrom ??

Beitrag von BEIER-Electronic Andy »

Hallo,

müssen wir mal testen, ob wir den Effekt hier auch irgendwie simulieren können... Ich melde mich, sobald ich was weiß.

Wie lang ist denn das Kabel von Akku zum Soundmodul?

Wie weit ist das Soundmodul von den Lautsprechern entfernt?
bastlerhennig
Beiträge: 2
Registriert: So 4. Dez 2011, 22:03

Re: Überstrom ??

Beitrag von bastlerhennig »

die boxen sind ca. 10cm entfernt. und die kabel sind 20-30cm lang.
Benutzeravatar
marco polo
Beiträge: 92
Registriert: Di 26. Okt 2010, 20:45
Wohnort: holland
Kontaktdaten:

Re: Überstrom ??

Beitrag von marco polo »

hallo beier team

this weekend i went to a model event in goes in the netherlands with my new usm-rc2
and i experienced the same
used two different powerpaks 1 lead acid 12v 7,2 ah and 1 nimh pack 12 v 4000 mah
both with the same outcome
lenght off the leads for the speaker is the original lenght
power leads are about 25 cm
used one 4 ohm ls-4r-25w-90 speaker on output one
i experienced it with volume settings above 70%
the red led is then constant on and the sound file is played once
after that everyting still works normall but the led stays on

i hope i helpt you with this information

gr marco polo
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4557
Registriert: Mi 17. Dez 2008, 07:37

Re: Überstrom ??

Beitrag von BEIER-Electronic Andy »

This problem should be fixed with the firmware V1.00b :(

Can you please test, if you get the "Überstrom" also, if you pluged off the connector X3?
Benutzeravatar
marco polo
Beiträge: 92
Registriert: Di 26. Okt 2010, 20:45
Wohnort: holland
Kontaktdaten:

Re: Überstrom ??

Beitrag von marco polo »

hallo beier team

during the test of last weekend there was nothing conected to the outputs 1-12
used digital mode
prop 3 in nautic mode
20 aditional sounds where programed
7 random sound where programed
outputs are programed but not yet used or tested
i had made some changes to the output volume
some of them are above 100% and some below
but i have not noticed any differents in the sound volume to the once that were changed
next weekend will do some more testing
i shall put all the output volumes back to 100%
i also try to make some messurements of the current and power
have you got some tips on wich in - outputs our pins you want to know the readings
should it be done with update version h or i
ore whit both of the updates
is it usefull for you that a make a recorded diagnose ond the sd card and mail it

btw your doing a great yob
youre fast on responding
an can solve the most problems in a very short time
super !!!!!!!!!!!!!!!!!!!!!!!!!


greetings marco polo
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Benutzeravatar
BEIER-Electronic Andy
Administrator
Beiträge: 4557
Registriert: Mi 17. Dez 2008, 07:37

Re: Überstrom ??

Beitrag von BEIER-Electronic Andy »

Measurements of the current and power are not really necessary.

The overcurrent is not really a overcurrent. It's more a disturbance (probably caused by the amplifier)...

But the idea with the diagnosis is very good! It would be great if you can send me some recorded diagnosis files. But remember, the diagnosis file will be always overwritten at every start (power on) of the USM-RC-2.
Benutzeravatar
marco polo
Beiträge: 92
Registriert: Di 26. Okt 2010, 20:45
Wohnort: holland
Kontaktdaten:

Re: Überstrom ??

Beitrag von marco polo »

send the diagnose by mail to you
hope they are helpfull

gr marco polo
groeten uit Nederland,
Niets is zeker, en zelfs dat niet.
Antworten