Seite 1 von 1

Servo-output has its own life

Verfasst: Mo 9. Mär 2015, 17:11
von Leonard
I have a SM-IR-16-2 with a speedregulator on IR-servo-1.
In Sound Teacher I have set it to Direct servocontrol via channel 2.
It works fine as long as I switch on in this sequence:

Transmitter
USM-RC-2
SM-IR-16-2

but if I switch off the transmitter or select another model, the engine on the speedregulator on SM-IR-16-2 are starting to run.
Sometimes it also happens if I switch on the SM-IR-16-2 without any IR connection.

If I park the trailer, so the IR connection are disabled, it stands still.

Re: Servo-output has its own life

Verfasst: Di 10. Mär 2015, 07:38
von BEIER-Electronic Andy
Hallo Leonard,

wenn das USM-RC-2 vom Empfänger keine Impulse bekommt, werden die Servoausgänge am SM-IR-16-2 bei der direkten Servoansteuerung momentan auf den Miminal-Anschlag (1,0ms) gefahren, was beim Fahrtregler ja leider Vollgas entspricht :?

Dieser Fehler wird beim nächsten Update behoben. Das Update wird wahrscheinlich so in ca. 2-3 Wochen als Beta-Version zur Verfügung stehen.

Re: Servo-output has its own life

Verfasst: Sa 14. Mär 2015, 15:52
von Leonard
I have changed from using Futaba Fasst to FrSKY Taranis Plus with the X8R receiver and it did the trick.
Now I can change model or switch off my transmitter and the IR Servo will not react.