Input X1/6-7 to Brake or reverse light
Verfasst: Di 16. Dez 2014, 13:24
I am using Servonaut E20 and therefore I run USM-RC-2 in Mix-mode.
Brake and reverse output from E20 is connected to Input X1/6-7 on USM-RC-2.
It is connected that way, so the signals will be transmitted via IR to the trailer.
It works fine as long as I use it to switch a specific output, but I want to use the combined rearlight, and therefore I need the brake-signal to connect to the function Brake.
I think it is not just easy, because it then have to disconnect the automatic brake and reverse detection from the speed of the engine.
Brake and reverse output from E20 is connected to Input X1/6-7 on USM-RC-2.
It is connected that way, so the signals will be transmitted via IR to the trailer.
It works fine as long as I use it to switch a specific output, but I want to use the combined rearlight, and therefore I need the brake-signal to connect to the function Brake.
I think it is not just easy, because it then have to disconnect the automatic brake and reverse detection from the speed of the engine.