Seite 1 von 1

double tap speed controllers

Verfasst: Mi 30. Okt 2013, 16:16
von astecme
Hi, there are a number of speed controllers on the market that are of the "double tap" variety. This refers to the fact that the first time reverse is selected it activates a brake function. The second time reverse is selected the ESC goes in reverse.

Is it possible to add this as an option so that with a "double tap" esc the revrsing engine sound is not selected until the second "tap"?

Thanks

Allan

Re: double tap speed controllers

Verfasst: Do 31. Okt 2013, 12:25
von BEIER-Electronic Andy
Hello Allan,

the Sound-Teacher has this option already. Please go to "Configuration" -> "Engine sound" and activate the option "Speed controller has a braking function".

But we don't know if these option works 100% correctly with every ESC...

Re: double tap speed controllers

Verfasst: Do 31. Okt 2013, 13:19
von astecme
This option provides a delay in the start of the sound and not a double tap. double tap would need the selection of reverse twice. first is brake second would be reverse and trigger the accompanying sound.

Allan

Re: double tap speed controllers

Verfasst: Mo 4. Nov 2013, 15:30
von BEIER-Electronic Andy
Hmmm.... normaly it should exatly do what you want.

But at the USM-RC-2 you have to stay 0,5s in neutral position between the two taps! Do you mean this with "delay"?

Re: double tap speed controllers

Verfasst: Di 5. Nov 2013, 18:26
von astecme
ah , no.

with the USM-RC2 if you e.g. brake and leave the brake on for more than 0.5 seconds the the USM-RC2 starts to play the reverse sounds. A double tap ESC applies the brake for the first reverse application and then reverses on the second.

SO what I am asking is if the USM-RC2 could do the same . i.e. on the first application of reverse it will simulate brakes. On the second application it will start the reverse sounds. This will then match the double tap ESC's e.g. Tamiya TEU 105BK, Hobbywing 180 brushed . etc.

Thanks

Allan

Re: double tap speed controllers

Verfasst: Mi 6. Nov 2013, 11:28
von BEIER-Electronic Andy
I've tested it again and I think it works exactly in the way you want:
  1. Throttle stick forward > Motor forward, sound forward
  2. Throttle stick backward > Motor brakes, brake sound and then idle sound
  3. Throttle stick in neutral > Motor off, Idle sound
  4. Throttle stick after 0,5s backward > Motor backward, sound backward
Can you send me please your project file (*.usm) and maybe a recorded diagnosis file from the SD card (DIAGNOSE.DAT) with this moving sequence. To record a diagnosis you have to activate this function in the Sound-Teacher (Configuration > Gereral).