Seite 1 von 1
smoke generator
Verfasst: Mi 2. Okt 2013, 15:24
von darentz27
I have a velleman switch with LED and a switchrelay.dont know how to connect these to my usm-rc-2.is there anybody white can make a drawing of the weiring?
Re: smoke generator
Verfasst: Mo 7. Okt 2013, 11:22
von BEIER-Electronic Eric
Hello,
can you please tell me the exact name of your vellemann product since there are a lot of different types on the market.
Re: smoke generator
Verfasst: Di 8. Okt 2013, 13:28
von darentz27
Velleman r1900b
Re: smoke generator
Verfasst: Mi 9. Okt 2013, 15:46
von BEIER-Electronic Eric
what do you want to control with that switch and relay? Do you want to switch the relay on/off with the vellemann switch?
Re: smoke generator
Verfasst: Do 10. Okt 2013, 11:54
von darentz27
I want to turn off/on the usm-rc-2 with the switch.the relais is for the smoke generator.
Re: smoke generator
Verfasst: Di 15. Okt 2013, 08:18
von BEIER-Electronic Eric
sorry, but i dont understand. What should happen if you push the button of the switch?
Re: smoke generator
Verfasst: Di 15. Okt 2013, 11:26
von darentz27
I want to power on/off the usm-rc 2 with the switch.if i push the switch the usm rc 2 will go on .if i push the switch again the usm rc 2 will go off so i can ride with usm rc 2 on and off.
The relais must be connected to the smoke generator on output 12 because it has more amps than the usm rc 2 can handle therefore is use a relais.
Re: smoke generator
Verfasst: Mi 16. Okt 2013, 13:46
von BEIER-Electronic Eric
I want to power on/off the usm-rc 2 with the switch.if i push the switch the usm rc 2 will go on .if i push the switch again the usm rc 2 will go off so i can ride with usm rc 2 on and off.
First, this is not possible because you want to use a push button. If you want to switch on/off the USM-RC-2 you will need a switch like we use in our Video Tutorial 2:
http://www.youtube.com/watch?v=CyIYOMSxfq8
The relais of your smoke generator can be switched on with any output of the USM-RC-2. Just configure the output you want to use as static. Now you can switch on the output with a prop channel or any sound. Don't forget to use a recovery diode at the relay.