Seite 1 von 1

Anchor sound and anchor control with same command

Verfasst: Do 23. Mai 2013, 17:43
von Oenoe1958
Hi,

I have the USM-RC-2 and i want to let you all know that it's great...
But i want the anchorchain sound to play when i give the anchor motor commands (up & down)
The command is given with a proportional channel ( Robbe 4+4 prop. module and Robbe prop. 8 decoder.)
Now i also give a command to start the sound by a multiswitch 16 and decoder.

What's the best possible sollution ?

With regards,

André

Re: Anchor sound and anchor control with same command

Verfasst: Fr 24. Mai 2013, 08:42
von BEIER-Electronic Andy
How do you control the motor? With a speed controller?

Re: Anchor sound and anchor control with same command

Verfasst: Fr 24. Mai 2013, 17:35
von Oenoe1958
Hi,
No, with a relais switch module.
The relais switch module is controlled by the Multi switch 16
The motor is a modified servo.

With regards,

André

Re: Anchor sound and anchor control with same command

Verfasst: Mo 27. Mai 2013, 07:29
von BEIER-Electronic Andy
Ok, just connect the 2 outputs from the multiswitch 8 decoder which goes to your relais switch module, also to 2 switching inputs (X1/4 - X1/7) of the USM-RC-2. Then assign the anchor sounds to the 2 switching inputs in the Sound-Teacher.

Re: Anchor sound and anchor control with same command

Verfasst: Mo 10. Jun 2013, 17:13
von Oenoe1958
oké...
Yes, this works!
Thank you verry much.

Greetzz
Dree