Seite 1 von 1

How to get the best sound experience for the truck?

Verfasst: Di 14. Mai 2013, 09:57
von Dio
Have been playing with this module for about 2 months now, but still find it hard to get best sound experience when editing sounds for different drive/motion sounds of the truck. Just wondering about what rpm range/action of the engine is best suiteable for the different slots, lenght of the file and what sound will overlap the other in the different stages (primary, secondary etc.)?

Best regards

JT
Norway

Re: How to get the best sound experience for the truck?

Verfasst: Mi 15. Mai 2013, 07:50
von BEIER-Electronic Andy
Hello Dio,

yes it's not easy to make a good sound for a sound module and it needs a long time and many experience. Especially when you want to have more than 1 gear.

It is also almost impossible for us to described in a few sentences on how to create a "good" sound. But you can send your sounds to us and we will check what we/you can improve.

Some general hints:
  • The loops for idle and driving (FG1-5) sounds should be long, about 5-10 seconds (or longer).
  • The driving sounds (FG1-5) should be recorded at a slow and constant(!) RPM of the motor.
  • The sounds for vehicle start/stop an gear change sounds should be short, about 1-2 seconds. The module does not mix these sounds with the idle or driving sounds. This means when a gear change sound is playing, the driving sound is off at this moment.
  • Don't use too much gears! Please not more than 2 or 3... Or only 1, because it's much easier to make a good sound for only one gear.

Re: How to get the best sound experience for the truck?

Verfasst: Mi 15. Mai 2013, 11:15
von Dio
Thank you Beier Team for your input on this area.

New question: Do you have any experience or wiring diagram for hooking up Servonaut E20 ESC to the module? I know i have to set it to Mix Mode and readout from the motor to 1/4 and 1/5. Do you have to use the "schalt cable" and "reverse/brake" output for leds on the E20? Im just wondering since i got the E20 today and want to be on the safe side before i begin ;)

Best regards

JT
Norway

Re: How to get the best sound experience for the truck?

Verfasst: Mi 15. Mai 2013, 14:27
von BEIER-Electronic Andy
We have no own experience with the E20...

Because the E20 has a tempomat, the mix mode will be not wrong... But I've read in the manual, the E20 has an own output for external sound modules. Maybe you can use this for the USM-RC-2 (connected to X2/1).

You mean the "Schaltkanal"? You need this 2. channel at the E20 for changing forward and backward drive.

I think it's better to use the LED outputs from the E20. So you have more free outputs at the USM-RC-2 for other functions and the reversing light should work better.