Seite 1 von 1

intensity and leds

Verfasst: So 6. Jan 2013, 20:18
von marco polo
hi beier team

is it possible to change the refresh frequentie of the outputs
when i use normal bulbs they work fine
when i use leds i can change the intensity by changing the resitor value
when i use leds on the combined front / rear lights
and i set the intensity below 60% pwm
i see that the leds are dimed but the also start to flicker because of the set value of the pwm
is it possible to boost up the refresh rate of the pwm ??
so that the leds look to burn normal all the time for the human eye

just want to know if you could change it

greetings from holland

marco polo

Re: intensity and leds

Verfasst: Mi 9. Jan 2013, 10:35
von BEIER-Electronic Andy
Hello Marc,

we will check this at the next update...