Seite 1 von 1

[SOLVED] Physical installation

Verfasst: Mi 14. Okt 2026, 14:03
von Hansvg
How do you physically install the SFR-1-D?
There are no holes for screws or bolts.
Tie-wraps probably can do the trick, but not the sexiest solution.
Any suggestions?

Regards, Hans

Re: Physical installation

Verfasst: Mi 14. Okt 2026, 17:12
von Rascal
Hello Hans,

velcro tape can be used, see also page 10 in the manual.

There may also 3D printed cases around, try to google "sfr-1-d 3d printed case" or such.

Re: Physical installation

Verfasst: Do 15. Okt 2026, 07:17
von BEIER-Electronic Andy
I once saw an SFR-1-D at a client’s site where two threaded inserts had been glued between the cooling fins of a heatsink. I think that’s a good solution, too.

Re: Physical installation

Verfasst: Do 15. Okt 2026, 15:39
von Hansvg
I found one and printed it. Thanks!

Regards, Hans

Re: [SOLVED] Physical installation

Verfasst: Do 22. Okt 2026, 02:43
von thomas_fr68
Hallo Hansvg, bei mir sitzt der SFR-1-D eigentlich nur mit Klettband auf einem Stück Sperrholz... Das hält seid dem Frühjahr ohne Probleme, ich sag mal ohne Drucker ging das halt schneller. Hab nur drauf geachtet dass die Kühlrippen frei bleiben, warm wird er ja trotzdem.