Seite 1 von 1

3. Fahrsound im USM

Verfasst: Mi 16. Sep 2026, 16:07
von Elektroschocker
Hallo in die Runde!

Ist es möglich, einen 3. Fahrsound, der proportional gesteuert werden kann, im USM umsetzen?
Der Hintergrund ist der, wenn man wie ich einen Baukran als Modell hat, der 3 Antriebe mit stufenloser Steuerung hat, dass man jedem Antrieb einen Fahrsound zuordnen könnte. In echt hören die sich ja auch unterschiedlich an.

Wäre für so etwas noch Platz im Speicher/Prozessor?

Re: 3. Fahrsound im USM

Verfasst: Do 17. Sep 2026, 01:48
von MdG-77
I hope English is oke.

Is there no option to create a advanced Mix in your radio?
With one proportional Motor sound you can link Prop-channel 1 (in the Beier module) to a higher channel from your radio and create three Mixes or more if needed.
So the higher channel gets all the inputs from your crane functions.
In most machines there is still one single Diesel engine, which is linked to all Hydraulic functions.

I’ve used this setup for one of my models and works great. (I’m using FrSky Ethos (will also work with OpenTX or EdgeTX) and for sure more.

The second motor can be a different engine sound (more with Hydraulic effect)
You can switch in between (when driving your crane, then use a more default diesel engine with engine-1 and for all crane operation, turn of engine-1 and turn on engine-2 which has more the hydraulic effect.

Re: 3. Fahrsound im USM

Verfasst: Do 17. Sep 2026, 14:09
von BEIER-Electronic Andy
Einen 3. proportionaler Fahrsound einzubauen, wäre ein enormer Aufwand und es müsste dazu sehr viel in der Software geändert werden. Daher denke ich nicht, dass da in naher Zukunft was kommen wird.