Error Code 18
Verfasst: So 10. Mai 2026, 11:45
Hello All
I am having problems with no motor output and over-current errors.
SFR-1 firmware v1.50b
Battery Nimh 7.2v or Lipo 2S 7.4 (configured correctly in ST for each type during tests).
Nothing else plugged into SFR-1 except data cable, S-Bus to Prop 6 and speaker. Lighting outputs disconnected.
Motor is external to truck and wiring is a simple two connections with good integrity. Definitely no shorts / loose wire.
Radio is RadioLink AT10 and receiver is R9DS configured for S-Bus.
Motor setup completed.
SFR-1 starts up normally (I have a start up function) and sound plays. When connected, the steering works fine. No error messages - everything as expected.
Cruise control is activated. If I run the throttle without a motor connected, the sound changes as expected. Braking and re-acceleration sounds work correctly. All as expected.
If I connect a motor, it doesn’t turn at all as the throttle is increased. On full throttle (still no motor turn) after a few seconds, the motor jolts momentarily as the SFR-1 shows error code 18 (using the diagnosis) and confirmed with the LED codes. On a couple of occasions I have had error code 1. As a result I removed the card, put it in thew PC, reformatted and loaded date back. Re-inserted the card. Starts up fine.
I don’t think the Code 1 is relevant personally. The Code 18 is puzzling. The Motor cables from the SFR-1 are free, no shorts or damage. No heat, no smell.
The diagnosis shows correct tx/rx control between 1000ms and 2000ms, centring at 1500ms. DAT attached.
Finally, I’ve tried two different motors. Each time the result is as above. PS both motors are new and spin freely.
I am having problems with no motor output and over-current errors.
SFR-1 firmware v1.50b
Battery Nimh 7.2v or Lipo 2S 7.4 (configured correctly in ST for each type during tests).
Nothing else plugged into SFR-1 except data cable, S-Bus to Prop 6 and speaker. Lighting outputs disconnected.
Motor is external to truck and wiring is a simple two connections with good integrity. Definitely no shorts / loose wire.
Radio is RadioLink AT10 and receiver is R9DS configured for S-Bus.
Motor setup completed.
SFR-1 starts up normally (I have a start up function) and sound plays. When connected, the steering works fine. No error messages - everything as expected.
Cruise control is activated. If I run the throttle without a motor connected, the sound changes as expected. Braking and re-acceleration sounds work correctly. All as expected.
If I connect a motor, it doesn’t turn at all as the throttle is increased. On full throttle (still no motor turn) after a few seconds, the motor jolts momentarily as the SFR-1 shows error code 18 (using the diagnosis) and confirmed with the LED codes. On a couple of occasions I have had error code 1. As a result I removed the card, put it in thew PC, reformatted and loaded date back. Re-inserted the card. Starts up fine.
I don’t think the Code 1 is relevant personally. The Code 18 is puzzling. The Motor cables from the SFR-1 are free, no shorts or damage. No heat, no smell.
The diagnosis shows correct tx/rx control between 1000ms and 2000ms, centring at 1500ms. DAT attached.
Finally, I’ve tried two different motors. Each time the result is as above. PS both motors are new and spin freely.