Seite 1 von 1

Building box for speaker

Verfasst: Do 26. Feb 2026, 10:47
von FreekS
Hello!
I have bought my first sound module RC-3 with 5cm diameter speaker. It is to be built into a model ship - actually a Dutch tanker converted in WW2 to aircraft carrier. The ship has a Swordfish on deck with running engine.
IMG_1732.jpeg
IMG_1732.jpeg (2.23 MiB) 2110 mal betrachtet
The ship is made of 3D printed components, and I am going to get the engine sounds, swordfish sounds and lights controlled by the RC-3.

What is the advice to build a speaker box inside the ship?
- speaker aimed to top?
- does the size of the box matter?
- walls of box thick or thin?
- coins do think with 20% infill to save weight?
- foam inside the box?
-box mounted on rubber feet to prevent contact with hull?

Thanks!

Re: Building box for speaker

Verfasst: Do 26. Feb 2026, 15:05
von Oldchap
Well, I'll try to give some answers:

- the bigger the box, the deeper the frequencies that can be emitted

- foam in the box suppresses reflexions

- thick walls can suppress unwanted noise

- rubber feet can also suppress noise

Okay, these recommendations are more important in HiFi studios than in models, but why not follow? :mrgreen:

Re: Building box for speaker

Verfasst: Do 26. Feb 2026, 16:57
von Rascal
Interesting boat!

I would aim the speaker to the top, ideally towards some opening in the deck if any.
If it's not that big it may also be installed vertically facing towards the bow or stern.
Rubber feet are IMHO not necessary for the box.

Alternatively an exciter can be used to emit the sound via the hull surface, no box will be needed then.

I would decide this based on the space and conditions inside the hull, considering that weight should to be installed as low as possible to avoid listing.