BEIER-Electronic

Hi

All wired in but can’t get any sound outputs work ok have ordered a pot as can’t get transmitter to adjust volume that way. Yes I do have experience with your systems as I have USM RC 2s & 3s?

What do the LEDs on the MSM-1 do when you turn on the power?

Hi

Green on blue flash a couple of times then solid green when I hold three way switch in position as instructed blue light comes on then nothing happens and light goes off just wondering if I would be better with using a stick input?

Docomar750 hat geschrieben: ↑Di 18. Mär 2025, 19:24Green on blue flash a couple of times then solid green when I hold three way switch in position as instructed blue light comes on then nothing happens and light goes off just wondering if I would be better with using a stick input?

What comes between "I hold three way switch in position" and "then nothing happens", i.e. did you release the switch after 2 seconds when the blue light came on and then move the switch to A or D to raise or lower the volume respectively?
Or did you just keep on holding the switch?

Tried both ways nothing hopefully the volume pot arrives soon then I can test properly as it’s the beier 100k pot

Unfortunately, the volume control pot won't help, as it only makes the volume quieter, not louder (than without the pot).

What model number did you set on the MSM-1? If you've already changed the model number, please set it back to no. 1 and test if the sound works.

Do you have the K-USB-2 data cable?

Hi

Yes set back to model 1 no sound was on ship 2 and yes usb data cable.

Can the data cable be used and what software would be needed?

There's also a Sound Teacher for the MSM-1. Not official yet...

You can't edit projects with the Sound Teacher. However, you can:
- Run and record a diagnosis using the data cable
- Update firmware
- Re-transfer the sound image of the 14 models

You can download the Sound Teacher here:
https://www.beier-electronic.de/modellb ... V1.00a.exe

Then, please run a diagnosis and start a record. Try enabling a sound while recording.

ok

sound teacher running diagnostics can see sound activating during testing (ie sound Nr i can see values changing) no sound tried everything it says in the manual tried 3 speakers still no actual sound. Now also when switching on i get green LED blue flashing 5 times but the red randomly coming on for 6 seconds. I take it there should be voltage on the sound pins when a signal is produced but on test all i get is continuity (short?)