Seite 1 von 1
Eliminate Shifting in Reverse
Verfasst: Di 11. Mär 2025, 02:44
von Peterbilt379
Hi All,
I apologize if this question has been asked and answered. I don't want gear shifting or gear shifting sounds when going in reverse. I've tried to understand the driving modes to know if that is the problem. Any help would be greatly appreciated.
Thanks!
Rob
Re: Eliminate Shifting in Reverse
Verfasst: Di 11. Mär 2025, 07:54
von BEIER-Electronic Andy
Hello Rob,
I think I don't understand the question. You haven't set any gears in the driving sound diagram in your project.
Re: Eliminate Shifting in Reverse
Verfasst: Di 11. Mär 2025, 11:13
von Rascal
Hello Rob,
as pointed out by Andy there are currently no gears configured in the driving sound diagram. You need to configure the number of gears for forward and reverse first under
Configuration > Engine sound > Engine sound according to your preference.
- Then enable the option "Play change sound parallel to engine sound".
- Add the shifting sound to sound-slots "Change FG# --> FG#:" for up-shifting and (if desired) "Change FG# <-- FG#:" for down-shifting.
- Do not add sounds to the sound-slots "Change FG# --> FG# (backw.):" and "Change FG# <-- FG# (backw.):"
If only one reverse gear is configured then no shifting sound will be played anyway.
See pages 101-102 in the manual for details of configuring the driving sound diagram and related options.
Re: Eliminate Shifting in Reverse
Verfasst: Mo 17. Mär 2025, 05:49
von Peterbilt379
Hi all,
My apologies and Thanks for the reply. With my current configuration, when I push the throttle up to go FWD, my shifting sounds will play. When I begin to slow down, and pull the throttle stick back, the Jakes sound will play........both of these audio sounds also occurs when I move the throttle into reverse. I'm sure I need to tweak some things... I was trying to follow those instructions, but it seems I came up short. I appreciate all the helpful information. The only slot I populated was FG1 normal (shifting) and FG1 slow down (Jakes). I will attempt to follow both of you suggestions.
Thank you
Rob