Seite 1 von 1

Anfahrgerausch functioniert nicht.

Verfasst: Mi 11. Dez 2024, 11:06
von Riny
Hello all,

I have a USM-RC2 soundmodule and everything works fine except the motorsound will not rev up when driving.
The motor control unit (Sabertooth 2x32) works as should be so there could not be the problem.
I use a Frsky Transmitter/receiver.
Connections are as the schematics by Beier. (so from receiver to 1 and from 1 to the motor control and same for 2nd channel.)
The motorcontrol is not used for powering the receiver.
The sounds are from Beier and also used in other models and there it works fine.

If any have a solution or maybe an idea, please let me know since i have tried everything what came up in my mind and i am out of ideas.

Thx in advance,

Riny

Re: Anfahrgerausch functioniert nicht.

Verfasst: Mi 11. Dez 2024, 11:40
von dark-angel712
Hello Riny

Have you activated “quick switching” in the settings?

Re: Anfahrgerausch functioniert nicht.

Verfasst: Mi 11. Dez 2024, 12:45
von Riny
Yes, i have tried all possibilities

Re: Anfahrgerausch functioniert nicht.

Verfasst: Mi 11. Dez 2024, 13:20
von Rascal
Hello Riny,

please upload the project file (*.usm) for us to check.

Re: Anfahrgerausch functioniert nicht.

Verfasst: Mi 11. Dez 2024, 19:05
von Riny
Hello Rascal,

Here is the USM file[attachment=0]Tiger1.usm

Re: Anfahrgerausch functioniert nicht.

Verfasst: Do 12. Dez 2024, 00:42
von Rascal
Hello,

you assigned a SBUS/SUMD channel to Prop #1 and #2. Go to Configuration > S-Bus/SUMD and remove the entries under Prop #1 and #2 so it shows "-" instead. The throttle signal will then be received via X2/1 and X2/2.

Re: Anfahrgerausch functioniert nicht.

Verfasst: Do 12. Dez 2024, 10:39
von Riny
Hi Rascal, thx for the answer.
Im goin to check/change this setting.
I let u know the result 👍👍

Re: Anfahrgerausch functioniert nicht.

Verfasst: So 15. Dez 2024, 19:39
von Riny
Hello Rascal,

thx fir the help, it works now :D

Riny