Seite 1 von 1

Servonaut E20 and brake/reverse light

Verfasst: Di 10. Jul 2012, 18:57
von Leonard
I am using Servonaut E20 because of its Tempomat-funktion.
I like the way the brakelight is on allways, then the stick is lower, and that the reverselight is on, allways then the truck is in reverse.

How do I make USM-RC-2 understand this light ?
I will use the IR to the trailers light, so I need to have the brake and reverse light in the same way.

Re: Servonaut E20 and brake/reverse light

Verfasst: Mi 11. Jul 2012, 07:25
von BEIER-Electronic Andy
Hello Leonard,

if you use the Servonaut E20 with it's tempomat, then you have to use the USM-RC-2 in the "mix mode".

When you drive backwards the reverse light is on.

The braking light should also work in the way you want. Maybe you have to adjust the setting "Threshold for brake light". And you should turn on the option "Brake light remain on for x seconds".

The lights for the trailer (SM-IR-16-2) are working in the same way.

Re: Servonaut E20 and brake/reverse light

Verfasst: Mi 11. Jul 2012, 11:30
von Leonard
I know to use the "mix-mode", and I have experimented with treshold and brakelight remain on, but it is not the same as the way the Servonaut shows the brakelight.
I think I have found a way to make the reverselight the same way, by calling it "Static" and mixing the channels on the remote.

I must live with the fact, that I cannot get the brakelight the way I want it.

Re: Servonaut E20 and brake/reverse light

Verfasst: Do 12. Jul 2012, 07:39
von BEIER-Electronic Andy
Das Problem wird wohl sein, dass das USM-RC-2 das Bremsen erst erkennt, wenn man die Geschwindigkeit deutlich reduziert.

Wenn Du am Soundmodul noch einen freien Prop.eingang hast, kannst Du ja das Bremslicht auch über eine statische Funktion schalten, indem Du den Gaskanal vom Empfänger zusätzlich auf diesen Prop.eingang legst.