Seite 1 von 1

SFR-1 Vs brushless autrunner

Verfasst: Mo 19. Aug 2024, 14:31
von Remi
good morning! I would like to know how I could make a brushless outrunner motor (low rpm) communicate with the SFR -1 module because I would like to remove the brushed (brushed motor) in the wheel loader traction. Simply put, trick the module or part of it to make it usable anyway. :roll:

Re: SFR-1 Vs brushless autrunner

Verfasst: Mo 19. Aug 2024, 17:41
von Rascal
Hello Remi,

the SFR-1 can only work with brushed motors, for brushless motors a brushless ESC is needed.

You could connect that brushless ESC to one of the servo ouputs of the SFR-1 if and control it via the throttle signal ("speed" in the Sound-Teacher menu). No motor will be connected directly to the SFR-1 then.

Should you go this route get a brushless ESC without BEC, or disconnect the red wire and isolate it if a BEC is included.

Re: SFR-1 Vs brushless autrunner

Verfasst: Mo 19. Aug 2024, 18:34
von Remi
hello, thank you for your prompt and competent response. Being able to use brushless motors means - as you well know - taking a huge step forward, leaving "all" the negative aspects that an electric motor entails. Many thanks :)

Re: SFR-1 Vs brushless autrunner

Verfasst: Mo 19. Aug 2024, 20:29
von Remi
Hello Rascal, hi, writing to me that no engine will be connected to the sfr-1, do you actually mean that I would lose the engine sound of the module? Only the light control would remain active? :|

Re: SFR-1 Vs brushless autrunner

Verfasst: Mo 19. Aug 2024, 22:16
von Rascal
Hello,

you would not lose the engine sound since the throttle signal is still routed into the SFR-1. But when no motor is connected the motor stage of the SFR-1 will be "wasted".
In this case it may make more sense to get a brushless ESC (which you would need anyway) and a USM-RC-3 instead.

Use the SFR-1 then in another model with a brushed motor.