Resistor LED Free
Verfasst: So 5. Mai 2024, 09:36
Hi
Just a thought is some of my older toy RC conversions I have used a light unit from RCLaneBoys. He produces and freely gives the designs for this unit. The interesting bit is it is negatively switched but requires no resistors the LED chip driver he uses makes sure only the current required and voltage that is needed for the LED. It’s a very small unit about 2cm x 3cm, I think due to the size each solder pad connection is only rated to 2 x LEDs each. I think it would be wonderful if this technology was on the Beier systems. I am competent and sure most of RC enthusiasts are ok with resistors and soldering, but I know from clubs and Facebook this but some people of from switching. I feel this sort of technology could make what is already I personally think the best product on the market into and unbeatable sound and light card.
Just a thought
Darren
Just a thought is some of my older toy RC conversions I have used a light unit from RCLaneBoys. He produces and freely gives the designs for this unit. The interesting bit is it is negatively switched but requires no resistors the LED chip driver he uses makes sure only the current required and voltage that is needed for the LED. It’s a very small unit about 2cm x 3cm, I think due to the size each solder pad connection is only rated to 2 x LEDs each. I think it would be wonderful if this technology was on the Beier systems. I am competent and sure most of RC enthusiasts are ok with resistors and soldering, but I know from clubs and Facebook this but some people of from switching. I feel this sort of technology could make what is already I personally think the best product on the market into and unbeatable sound and light card.
Just a thought
Darren