Noob question on engine sounds
Verfasst: Di 31. Jan 2023, 06:12
So I've finally sat down and done my first steps into building my Globe Liner, which is to wire up the electronics first before even building to see if they'll even work.
I have the USM RC 3 hooked up with six patch cables for 1 to 6, with 1 and 2 swapped, because I'm using a Flysky GT5 pistol grip TX, and BS6 RX.
I actually got the Detroit Diesel file uploaded and working, and we're getting good noises out of the speaker.
However, here's the conundrum.
I twiddled with the 'sound simulator' part, and it sounds like the DD file has a decent Engine Brake rumble sound effect. On my laptop, when I run the slider to accelerate, I get standard engine sounds going through two gears, while sliding it back to center gets you a nice deep engine grumble.
But trying to get the actual radio assembly to make the rumbly engine brake noise is near impossible while playing with my handset. I can't seem to get it to reliably pop over to grumbly noises as it's decelerating, and the few times it does kick in, it doesn't want to disengage when going back to acceleration.
Off the top of anyone's head, do you have any ideas on what settings will run it all smoothly, or would you require diagnostic files to sort through?
Thank you for your help, in advance.
I have the USM RC 3 hooked up with six patch cables for 1 to 6, with 1 and 2 swapped, because I'm using a Flysky GT5 pistol grip TX, and BS6 RX.
I actually got the Detroit Diesel file uploaded and working, and we're getting good noises out of the speaker.
However, here's the conundrum.
I twiddled with the 'sound simulator' part, and it sounds like the DD file has a decent Engine Brake rumble sound effect. On my laptop, when I run the slider to accelerate, I get standard engine sounds going through two gears, while sliding it back to center gets you a nice deep engine grumble.
But trying to get the actual radio assembly to make the rumbly engine brake noise is near impossible while playing with my handset. I can't seem to get it to reliably pop over to grumbly noises as it's decelerating, and the few times it does kick in, it doesn't want to disengage when going back to acceleration.
Off the top of anyone's head, do you have any ideas on what settings will run it all smoothly, or would you require diagnostic files to sort through?
Thank you for your help, in advance.