Seite 1 von 1

loop function and nautic

Verfasst: Do 23. Feb 2012, 21:00
von marco polo
hi beier team

i use a fc16 robbe transmitter whit a 8413 robbe swicht module
when i program aditional sound to a switch whitout a memory funtion in the nautic section
and a aditional sound whit once-complete funtion
the sound plays in a continius loop when i leave the swicht in the on position
and not only onces
it only stops on the end of the sound file when i turn off the switch
in the mode once immed. stop it's the same
loop once and loop immed. stop are working ok
the sounds assingd to the sticks (ekmfa mode) are working the wright way
in the usm-rc this option works ok whit these settings
am i doing something wrong ??
or is this a problem whit the 8413 mudule that i use

marco polo

Re: loop function and nautic

Verfasst: Fr 24. Feb 2012, 08:39
von BEIER-Electronic Andy
We know this "problem"...

In this case the sound plays once and completely to the end. But if then the start signal (your nautic switch) is still applied, the sound will just start again.

Maybe we will change here something at the next major update...

Re: loop function and nautic

Verfasst: Sa 25. Feb 2012, 00:06
von marco polo
ok no worry's
with patience it all will be fixed

thank you very much

marco polo