Seite 1 von 1

cold and warm start

Verfasst: Do 16. Feb 2012, 00:25
von marco polo
hello beier team

I use two different soundfiles for the cold and warm start
and found that the cold start file only plays one time
even when i set the time to the max of 99 seconds
it is not posible to play the cold start more than once

greetings from holand

marco polo

Re: cold and warm start

Verfasst: Do 16. Feb 2012, 07:25
von BEIER-Electronic Andy
Hello marco polo,

please send us your project file (*.usm)

Re: cold and warm start

Verfasst: Fr 17. Feb 2012, 00:09
von marco polo
hi beier team

send them by mail to you
i hope they are usefull to you
keep up the good work you are doing

thanks so far

greets for holland

Re: cold and warm start

Verfasst: Fr 17. Feb 2012, 08:39
von BEIER-Electronic Andy
I've tested this with your "aqr 8.usm" project, but it works correct...

If you set the "Time for warmstart" to 99 seconds, the engine sound must be OFF for 99 seconds (or longer) to play the coldstart again.

If you restart the engine before the 99 seconds are over, then the module will play the warmstart.

Re: cold and warm start

Verfasst: Fr 17. Feb 2012, 21:44
von marco polo
hmmmmmm

ok i think it's the translation were it went wrong :oops:
i thought it was the setting for the time the cold star would play when you restarted
and then after the time setting it only would play warm start
but with your explanation it's just the other way around :idea:
thanks for the translation
and also for the testing
i will give it a spin
and let it know

greetings marco polo

Re: cold and warm start

Verfasst: Mo 20. Feb 2012, 00:20
von marco polo
:D :D
yes that was it :oops:
thanks beier team

greetings from holland
marco polo