Seite 1 von 1

Cannon elevation with SFR-1-D

Verfasst: So 24. Jul 2022, 17:31
von thuat.bui
Anybody here successfully configure cannon elevation using servo? I know most of people are using motor for simplicity and natively supported by Beier SFR-1-D. However, I want to use my gimbal module for Gun Stabilization feature. Unfortunately, the component only works with servo, not motor.

Thanks for reading/sharing.

Re: Cannon elevation with SFR-1-D

Verfasst: So 24. Jul 2022, 23:46
von Rascal
Hello,

how do you normally control the gimbal - via switch or stick/potentiometer?

If stick/potentiometer - does it need to latch to hold the cannon in the desired elevation (ignoring the stabilization), or does the stick/potentiometer go back to neutral after selecting the elevation (cannon then remains in that position)?

Do you still have a receiver channel available and a free prop input at the SFR?

Re: Cannon elevation with SFR-1-D

Verfasst: Sa 30. Jul 2022, 11:46
von thuat.bui
You're right. I got the problem fixed with assigning the channel to a stick that can hold the position, not automatically return home.

All are fine now!

Thanks a lot