Hello,
the functions "LM: Rotating beacon" as well as "LM: Flasher" and "LM: Chaser light" use outputs 13-16 on the SM-IR-16-2 to 'create' the lights, i.e. you would need to connect 4 LEDs which will then display the pattern according to the selected function. This is meant for usage cases where you build your own beacon, flasher or chaser light.
See the
manual on pages 10 to 12 for details.
Also note that outputs 13-16 can only be used for the special light functions, i.e. it is not possible to control them independently. (The LM-XX-16-4 modules can do this in combination with the USM-RC-3, SFR-1 or UFR-1230.)
If you have a ready-to-use rotating beacon you can just switch it via any output from 1 to 12 that is configured as
output type "Static (Sound, Prop)" and use the function "Output X" to activate. See
here for a wiring diagram, "RKL" is the beacon.
If your beacon can handle higher voltages you may connect it directly to battery+ instead of the BEC.
If you have a 'made in China' beacon with servo connector (AX-510, AX-511) that is normally connected to the receiver you can connect it to one of the servo outputs of the SM-IR-16-2. There are several options how to control the beacon connected to a servo output, see
from this post onwards for detailed instructions but select the respective LM Servo instead.