Seite 1 von 1

Smoke Generator Fan speed

Verfasst: So 24. Okt 2021, 05:13
von tizdaz
Hi!

ok i have a Mist unit that I've made myself, it does not use a heating element, it uses small humidifiers, same as these:
mister.png
mister.png (193.7 KiB) 2147 mal betrachtet
It uses a fan that blows the mist through the tube, but i want the fan speed to alter when i give more throttle or less throttle etc so it gives the effect of more or less mist depending on the throttle.

I also want the fan to continue running when throttle is at idle, I've read the manual for the RC-2 and it states i can do this, but I'm un sure how to wire the fan up etc & what settings i need to change, I've changed this option from Heating element to smoke generator fan:
fan setting.png
fan setting.png (35.26 KiB) 2146 mal betrachtet
but I'm not sure now where i connect my fan to the module etc?

Any help much appreciated! Thanks :)

Re: Smoke Generator Fan speed

Verfasst: So 24. Okt 2021, 09:46
von Ralph Cornell
I think you've done everything right so far. The small fans are equipped with DC motors, which are, however, converted to three-phase motors by the smallest electronic components.
Here begins a problem. The operating frequency of the USM-RC-2 is 100 Hertz, and this rather low value can cause disturbances in the electronics of the fan, so that it runs irregularly, stops or sometimes even runs backwards. This doesn't happen with all fans, but it does. It depends on a try.
Connect the minus output (in your case output 4) with the minus of the fan and its plus with either the plus of the module or directly with the plus of the battery. However, I have doubts whether a value of 10% (Iddle) will still let the fan run. You have to remember that the voltage value is set by pulse width modulation. This "sawtooth voltage" causes the current to rise steeply at the switching edges. I would choose at least 50 or 60%.

Re: Smoke Generator Fan speed

Verfasst: So 24. Okt 2021, 12:21
von Rascal
Hello,

when the smoke generator is active it will continue to run while the throttle is idle, subject to the output's value under Option 1 "Smoke at standing (0-100%)", see Configuration > Outputs > Outputs USM-RC-2.

There are two ways to switch on the smoke generator output:
- Use function "Smoke generator on" -> runs continuously until you switch the function off again
- Use option "Smoke generator always on, when engine sound is on" -> runs continuously as long as engine sound is on

You can also set an option "Trailing smoke generator fan" to delay turning off the fan when the "Smoke generator fan" output is switched off. The options can be found under Configuration > Outputs > Output options.

Re: Smoke Generator Fan speed

Verfasst: So 24. Okt 2021, 20:47
von tizdaz
hi guys,

all sorted, i just wasnt sure how to connect fan to the sound module board.

Ive done it this way:

Connected the plus of the fan to output X1/8 on the RC-2 & connected the minus of the fan to output X3/10:

with these settings:
fan output.png
fan output.png (38.74 KiB) 2134 mal betrachtet
fan output2.png
fan output2.png (44.14 KiB) 2134 mal betrachtet
tried with a couple of different fans, seems to be working great, i will be setting it all up later tonight to test properly with rest of my electrics! :)

Thanks guys!