Seite 1 von 1

How does the the 7 functions switch ?

Verfasst: So 6. Mär 2011, 11:39
von Sune Nielsen
Hi Beier El...

I have a system that makes some effects on my light systems..
It uses common ground, and is to be placed between the light LED and a switch module...

I switch on the lights/lapms by connecting a negative pole to the respective lamp.
Can you tell me if the 7 multiswitch functions on you USM-RC has a fixed positive, and is switching on the negative poles ?

Re: How does the the 7 functions switch ?

Verfasst: So 6. Mär 2011, 18:11
von airknee
Hello Sune, :)

yes that's right, the USM use a fixed positive+ and the functions are all switched by negative-.

Common positiv+ and every connector used a single negative-.


Hope i've helped you a little....


Greetings Airknee :)

Re: How does the the 7 functions switch ?

Verfasst: So 6. Mär 2011, 18:27
von Sune Nielsen
Yes you did....

So this is perfect....
I'm close to go with the USM-RC then... I need 5 or 6 switches... So it's more than enough :)
And not much extra to get the sound-option :)

Thanks...

Beier feel free to verify the statement :)

Re: How does the the 7 functions switch ?

Verfasst: Mo 7. Mär 2011, 08:13
von BEIER-Electronic Andy
Yes, Airknee is right :)

The USM-RC switches the negative pole to the loads.

Re: How does the the 7 functions switch ?

Verfasst: Mo 7. Mär 2011, 15:55
von Sune Nielsen
And I can use the negative poles without using the positive poles? (in USM-RC)

Re: How does the the 7 functions switch ?

Verfasst: Di 8. Mär 2011, 07:14
von BEIER-Electronic Andy
Yes you can.

The positive pins of X3 are internaly just connected with X1/4.