Power switch
Verfasst: Sa 11. Jun 2016, 00:24
May I suggest a relay controlled main circuit breaker on the UFR 1230, when it comes to trucks,
many are so tight constructed that you can not immediately get to the battery and disconnect the power at this place when needed.
you might very well mount a switch on the main cable, but where do I find a switch that can withstand 60A and at the
same time is small enough to hide on the model.
My solution is probably to install a relay from a car, but space is scarce and it is not the optimal solution,
Servonaut has a built-in relay-controlled circuit breaker switch on the M20 + ESC.
I could of course use servonaut M20 + just as a relay but this is just 20A
My point is that it is not advisable to allow the model to stay turned on for a full day, we are some who talk more than we drive our trucks
and if I turn off the transmitter the model goes into failsafe and consume even more power by braking
I have not been able to find any information regarding the UFR 1230 enters hibernate at x number of minutes without use or something similar
many are so tight constructed that you can not immediately get to the battery and disconnect the power at this place when needed.
you might very well mount a switch on the main cable, but where do I find a switch that can withstand 60A and at the
same time is small enough to hide on the model.
My solution is probably to install a relay from a car, but space is scarce and it is not the optimal solution,
Servonaut has a built-in relay-controlled circuit breaker switch on the M20 + ESC.
I could of course use servonaut M20 + just as a relay but this is just 20A
My point is that it is not advisable to allow the model to stay turned on for a full day, we are some who talk more than we drive our trucks
and if I turn off the transmitter the model goes into failsafe and consume even more power by braking
I have not been able to find any information regarding the UFR 1230 enters hibernate at x number of minutes without use or something similar