Seite 1 von 1

problems with output sequence

Verfasst: So 28. Feb 2016, 20:46
von gidje
Hey,
I have a dangling usm-RC-2
Now I have the following problem.
I have 2x output programmed sequence
a sequence 1 and a sequece2
these two work well independently,
Now the problem if I have to sequence 1 and I switching sequence 2 in sequence then one goes off,
That problem also vice versa,
this is a bug in the software or I am doing something wrong.
I like to hear what is going wrong.
gideon

Re: Software V1.40

Verfasst: So 28. Feb 2016, 22:47
von Rascal
The behaviour is correct, only one sequence can be active. So if you start 2, then 1 will be stopped and vice versa.

Last sentence on Page 49 in the English manual.

Re: Software V1.40

Verfasst: So 28. Feb 2016, 23:25
von gidje
oke thanks,